While running MLD conformance test 9.2 core is getting generated.
Test setps:
1. ANVL: Listen (for upto <GeneralQueryRecvWaitTime> seconds) on <AIface-0>.
2. DUT: Send MLD General Query Message.
3. ANVL: Send MLD Report Message to <DIface-0> containing:
• IPv6 Source Address field set to link-local IPv6 Address of HOST-1
• IPv6 Destination Address field set to <McastAddrGroup>
• MLD Multicast Address field set to <McastAddrGroup>.
4. ANVL: Wait for <ProcessTime> seconds for DUT to process and add <Mcas- tAddrGroup> to its Multicast Address list.
5. ANVL: Send MLD General Query Message to <DIface-0> containing:
• IPv6 Source Address field set to link-local IPv6 Address of RTR-1 which is numerically less than the link-local IPv6 unicast address of <DIface-0>
• IPv6 Destination Address field set to link-scope all-nodes multicast address.
6. ANVL: Send MLD Multicast-Address-Specific Query Message to <DIface-0> containing:
• IPv6 Source Address field set to link-local IPv6 Address of RTR-1
• IPv6 Destination Address field set to <McastAddrGroup>
• MLD Multicast Address field set to <McastAddrGroup>
• MLD Maximum Response Delay field value set to 0.
7. ANVL: Verify that the Maximum Response Delay timer for <McastAd- drGroup> is set to zero.
While running above test, when group specific query is received we start gm_t_sg_expire timer.
Once this timer expires, we clear the corresponding entry.
During this sg->state was still set to JOIN. This happened because receiver went down without sending leave.
Added a condition to update the sg->state before starting the timer.
If receiver goes down without sending leave we will update sg->state to GM_SG_JOIN_EXPIRING or GM_SG_NOPRUNE_EXPIRING based on previous state.
If we receive a join then sg->state will be refreshed and will be updated to JOIN state.
Fixes: #13387
Signed-off-by: Abhishek N R <abnr@vmware.com>
Effectively a massive search and replace of
`struct thread` to `struct event`. Using the
term `thread` gives people the thought that
this event system is a pthread when it is not
Signed-off-by: Donald Sharp <sharpd@nvidia.com>
After doing "no ipv6 pim" and "ipv6 pim" on receiver interface in LHR,
mroutes were not created.
When we enable pim after disabling it, we refresh the membership on pim interface.
First we clear the membership on the interface, then we add it back.
For PIMv6 we were only clearing it, membership was not added back. So mroutes were not created.
Now added code to fetch all the local membership information into PIM.
Fixes: #12005, #12820
Signed-off-by: Abhishek N R <abnr@vmware.com>
Fresh ground-up MLD implementation with subscriber-tracking for MLDv2.
Intended to be adapted for IPv4 and replace the IGMP implementation at a
later point.
Tested in ANVL, currently at 94/116. Some issues/TODOs are left in the
code as CPP_NOTICE markers, but the code is very much good enough to
proceed since otherwise we're blocked on overall PIM v6 progress.
Signed-off-by: David Lamparter <equinox@opensourcerouting.org>
