Pathd uses a single debug struct with additional option flags to
configure different types of debug messages. This is not how debug
library is supposed to be used. The idea of option flags is to allow
more granular control of a single type, not to represent multiple types.
This commit adds a separate debug struct for each type which greatly
simplifies the code.
Signed-off-by: Igor Ryzhov <iryzhov@nfware.com>
Rework "debug pathd pcep [...]" command to support the following
configurations:
- configure one debugging log type at a time.
- deconfigure one debugging log type at a time.
- configure all debugging logs in one shot.
- deconfigure all debugging logs in one shot.
Signed-off-by: Farid Mihoub <farid.mihoub@6wind.com>
Signed-off-by: Brady Johnson <brady@voltanet.io>
Co-authored-by: Javier Garcia <javier.garcia@voltanet.io>
Signed-off-by: Javier Garcia <javier.garcia@voltanet.io>
This new dynamic module makes pathd behave as a PCC for dynamic candidate path
using the external library pcpelib https://github.com/volta-networks/pceplib .
The candidate paths defined as dynamic will trigger computation requests to the
configured PCE, and the PCE response will be used to update the policy.
It supports multiple PCE. The one with smaller precedence will be elected
as the master PCE, and only if the connection repeatedly fails, the PCC will
switch to another PCE.
Example of configuration:
segment-routing
traffic-eng
pcep
pce-config CONF
source-address ip 10.10.10.10
sr-draft07
!
pce PCE1
config CONF
address ip 1.1.1.1
!
pce PCE2
config CONF
address ip 2.2.2.2
!
pcc
peer PCE1 precedence 10
peer PCE2 precedence 20
!
!
!
!
Co-authored-by: Brady Johnson <brady@voltanet.io>
Co-authored-by: Emanuele Di Pascale <emanuele@voltanet.io>
Co-authored-by: GalaxyGorilla <sascha@netdef.org>
Co-authored-by: Javier Garcia <javier.garcia@voltanet.io>
Co-authored-by: Renato Westphal <renato@opensourcerouting.org>
Co-authored-by: Sebastien Merle <sebastien@netdef.org>
Signed-off-by: Sebastien Merle <sebastien@netdef.org>
